4 Replies Latest reply on Apr 16, 2012 5:35 AM by ibek

RiftSaw 3 - How to enable recovery?

ibek Apr 15, 2012 8:11 AM

Hi, I have tried to enable recovery of business processes after AS crash (simulated kill with signal 9) in JBoss AS 7.1 but I cannot still make it work.

I started with configuration BPEL module to use non-memory database exactly with this manual https://docs.jboss.org/author/display/SWITCHYARD/Update+BPEL+component+database?_sscc=t

As I watched the database in mysql, after I start the AS after crash, the database is cleaned which causes that processes aren't recovered. Do you know please how can I set the BPEL module to don't clean DB?

Thanks, Ivo

1. Re: RiftSaw 3 - How to enable recovery?

jeff.yuchang Apr 16, 2012 3:52 AM (in response to ibek)

Hi Ivo,

Are those tables been removed? or just those data (records) been deleted?

Thanks
Jeff
Actions
2. Re: RiftSaw 3 - How to enable recovery?

ibek Apr 16, 2012 4:26 AM (in response to jeff.yuchang)

Hi Jeff,

Only the records had been deleted.
Actions
3. Re: RiftSaw 3 - How to enable recovery?

jeff.yuchang Apr 16, 2012 4:59 AM (in response to ibek)

Hi Ivo,

Did you see the same when you stop the AS properly... like not by crashing the server with kill -9?

One thing to note is that in RiftSaw3, we haven't supported the fail-over feature yet, means that clustering feature is not supported in RS3.

Regards
Jeff
1 of 1 people found this helpful
Actions
4. Re: RiftSaw 3 - How to enable recovery?

ibek Apr 16, 2012 5:35 AM (in response to jeff.yuchang)

I didn't try to stop the AS in the middle of running process.

Yes of course, thank you ... it will be that because of the fail-over. I knew about the clustering. It is logical but i didn't realize that fail-over isn't supported too which actually recover the process from DB.

Thanks, Ivo
Actions

Go to original post